This clamp allows a solid and safe clamping method to hold your fork in a vise when it comes time to service your fork.
Item Specs:
- Two 12x3mm Neodymium magnets per half - quite strong.
- Width: 130mm
- 3D printed using PETG filament, a stronger alternative to the commonly used PLA material. Print settings built around strength (high fill% settings, thick perimeter walls).
- Material is soft enough to not damage your steerer tube but strong enough to hold it tight.
- Made in the USA.
Compatibility (non-exhaustive)
- 15.9mm / 5/8": Fox TALAS IFP Shaft
- 15.0mm 19/32": Marzocchi SFA/ATA air-piston shafts
- 12.7mm / 1/2": RockShox Vivid rear shock damper shaft, DHX RC4
- 10mm / 25/64": Fox and Marzocchi forks (damper and piston shafts)
- 9.53mm / 3/8": Unsure of what models, but a common size
- 9mm / 23/64": RockShox Ario/Bar/Monarch air-shock damper shafts
- 8mm / 5/16": Fox, Manitou and Marzocchi forks (damper and piston shafts
You might also like
Price
€145.90
Price
€269.90